In Windows 7 and earlier, open 'Disk Management' by right clicking on 'Computer' and selecting 'Manage', then 'Disk Management'.Attach the SSD as a secondary drive and load Windows from your existing drive.Note: if you simply need to format/reformat a drive, the following steps below will be needed, assuming your SSD has previously been initialized. Follow the below process, unless you are performing a clean installation of your operating system, or cloning to your SSD, both of which normally do this for you. To switch between the connected devices, simply press the Fn and corresponding allotted key from Q, W, and E keys.īefore you can use your new SSD you have to initialize and partition it. Once, all the devices are paired, you can turn on the Bluetooth on all the devices. As Q key is already used, take W key and repeat the above process. If you want to connect another device then the main procedure will remain the same but you would need to turn off the Bluetooth on the already connected device. When prompted, type the code on the keyboard that would be shown on the target device.įollow the procedure to complete the bonding and start using the keyboard wirelessly. The keyboard will appear in the list of the visible devices. Tap/Click on the Scan button on the target device. Press the Fn and Q key combination till the white light starts blinking rapidly. Turn on the Bluetooth of the device to which the keyboard is to be connected. Here is how to establish the wireless connectivity on the Drevo Calibur keyboards:

Drevo seer